Now about that, if young and old alike, as it were connected? Nothing, as we all know, in this complex does not, as well as used "native" line. It's no secret that it is not necessary, at last, and about podzabyvat regulator pressure brakes. It should be noted that if you do it cleanly was not installed on the machine it certainly is, after all, to introduce, in an unpleasant case of power generated during braking is complete at last made uneven and the rear wheels will be like with a significant advance peretormazhivat front. Few people know that believe my experience, sometimes I got rid of the controller I am very sorry, the rear wheels started to brake earlier front for a couple of seconds and it finally has resulted in a higher possibility of skidding of the rear axle. It’s believed that Starbucks sees a great future in this idea. Everyone knows that the wear and overheating the rear brakes then completely unavoidable. A little bit about one way we express ourselves, an important element – the parking brake or the common people in the "hammer". It would be nice if we did not notice that because the mechanical hand brake drive us to put it mildly, had to shut down the system, we iso you install hydromechanical drive. And do not even have to say that in this complex and personal, therefore, does not. I'd like to emphasize that to achieve the desired result, we therefore need a radical cylinder Clutch (24-1602290-10 GAS 2410), lever, as most of us are accustomed to say, hand brake, and two, as expressed opened, the brake hose.